Allow Modification of Drivers Floorpan for Taller Drivers
#25752 from Rob Hines · Recommended to the Board · Minutes (2019-01 Fastrack)
Thank you for your request. Effective 1/1/19, please make the following change to Touring
2-4:
9.1.9.2.9.d Interior Modifications
7. The driver’s side floor pan may be modified to accommodate larger/taller drivers. All
modifications shall be contained between the transmission tunnel, driver’s side rocker, rear
bulkhead. The modification shall not extend below the factory floor stiffener/frame rail. The
steel used in the modification shall be no thinner than .058”. All modifications shall be welded
in place. This modification shall serve no other purpose other than seating position.